How to glue wallpaper in the corners: Directions, gluing outer, inner Part, docking

Step-by-step directions for gluing inner gidpola.ru corners

After finishing, the most important problem can be uneven walls as well as the consequent folds on the wallpaper. It is also essential to take into consideration that as soon as the walls are twisted , the joints of background canvases could invisibly.

After gluing the last one in the front of the interior corner of the fabric must measure the remaining distance. It is measured from the edge of the glued cloth to the adjoining wall, the resulting figure is inserted 10-15 millimeters. When the partitions are extremely curved, the further figure could be .

Cut a strip equal to the resultant figure, taking into account the allowance. The surfaces have been treated with adhesive. Based on the sort of coating it may be only the wall or the surfaces.

The strip is then glued individually with the cut side to the wallsocket. The wallpaper should go on the opposite airplane.

If the glued background is sterile, then you have to make several smallish cuts perpendicular to the folds.

Level or slope on the adjacent wall is a vertical lineup. The distance from the corner is equal to the width of the last cut strip, never adding developments.

The surfaces have been smeared with glue, and then the coat is glued to the wall with the flat side towards the marked line. The cut goes onto the adjacent wall.

Protruding corner ought to be glued by analogy using an interior, but there are small differences, which also need to be taken into account when working.

Measured the space remaining from the glued background into the adjacent wall. Insert 20-25 millimeters to the captured figure.

A section is cut away, taking into account the added 20-25 millimeters.

Before gluing, the surfaces are treated with adhesive.

The even edge must be glued to the wallpaper already fixed on the walls, your own cut “goes” to the adjacent plane. If necessary, small cuts are made in the place of visiting the other background, smoothed and pressed into the wallsocket.

Draw a vertical strip on the adjacent wall at a distance of just glued cut strip plus 6-10 millimeters.

After applying the adhesive, the strip is placed on the wall using its flat side into the marked line, going over the edge of this already glued strip.

The joints have been smeared with adhesive and ironed using a roller. Following that, the upper layer is cut along the ruler and the two layers are joined together.

Comments are closed.